Winding the bobbin, Removing the bobbin, Setting up the bobbin winding – Kenmore 385.19365 User Manual
Page 43: To use the additional spool pin, Inserting the bobbin
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Winding the Bobbin
« Removing the bobbin
Gently slide the hook cover plate release button to the
right and remove the cover plate.
Lift out the bobbin
CT) Hook cover plate release button
@ Hook cover plate
Setting up the bobbin winding
Q] Lift up the spool pin (t). Place the spool of thread on
the spool pin with the thread (D coming off the spool
as shown. Attach the large spool holder (D, and
press it firmly against the spool of thread.
¡2}
Guide the thread around the thread guide.
S] Thread through the hole in the bobbin from the
inside to the outside. Put the bobbin on the bobbin
winder spindle.
To use the additional spool pin
Set the Spool stand under the additional spool pin,
place the felt, then insert into the hole.
© Spool pin
(g) Spool
® Large spool holder
® Additional spool pin
©Felt
® Additional spool pin hole
© Bobbin winder spindle
32