Kenmore 385.19365 - Manual (Page 61)

Maiiual Stitch Length
Press or “+” to adjust the stitch iength.
To decrease length, press
To increase iength, press “V*.
The pre-programmed stitch length setting is suitable for
most of your sewing needs. However, you can change
these settings to accommodate different fabric
characteristics or achieve a desired effect. Hold down
or V unti! you reach the desired setting.
The reverse stitch iength cannot be set longer than
1/8" (0.3 cm)
Variable Needle Position
These settings apply only to "stralghf stitch patterns #1
through #3, #10, #11. #19, and #30.
When you select stitch patterns #1 through #3, #10, #11,
#19, and #30, (see bottom of box on right), you can adjust
the ieft/right needle position. When you p r e s s t h e
needle position vm III move to the left.
When you press ‘V’, the needle position will move to the
right.
CD Left (0.0)
(D Middle (3,5)
CD Right (7.0)
Note:
When using the straight stitch foot, make sure to use
center needle position (D-
Otherwise the needle may strike the sewing foot and
possibly break.