Bartacking, Rflainorizing bartacking, Adjusting the evenness of bartacking – Kenmore 385.19365 User Manual
Page 93
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Bartacking
CD
Stitch pattern:
18
(D
Thread tension dial:
AUTO
® F: Satin stitch foot
Switching to “Low” speed setting. 4 lock stitches will be
sewn first. Then sew to the desired length and press the
reverse button.
The desired length has been now determined. Continue
sewing until the machines stops automatically.
* This stitch is used for reinforcement of the heavily
strengthened pari of a garment.
The maximum bartack length is 1” (2.5 cm) depending
upon fabric.
When you change the stitch length or stitch width, press
width or or iength"+” o r k e y .
® Starting position
(D
Ending position
® Rflainorizing bartacking When repeatedly sewing the same size bartack, press "MEM” key and restart sewing. Length required (D Reverse button CD Starting position Ending position ® Adjusting the evenness of bartacking Make a test on an extra piece of fabric to check your settings if the bartacking Is uneven, adjust the stitch length by turning the feed balancing dial as shown. (D Starting position ($) An extra length is left from the starting position ® Turn the feed balancing dial to V direction. © Matching the position. (Correct position) ® An extra length is let from the returning position. ©Turn the feed balancing dial to position.