Kenmore 385.19365 - Manual (Page 77)

c# is s ^ S ^ SS ^ ^
® stitch pattern; BH1
(D Thread tension diat; AUTO
(D R; Automatic buttonhole foot
* When you select the buttonhole stitch, the screen
indicates the message: “PUUL DOWN BH LEVER"
for a few seconds.
Sewing preparation
Q] Attach the automatic buttonhoie foot R. Make sure
the groove on the holder catches the pin on the foot,
when lowering the presserfoot.
® Groove
© Pin
[ 2 ] Puli the button holder to the back, and place the
button in it Push it together tightly on the button.
® Button holder
if the button is extremly thick, make a test buttonhole.
If it is difficult to fit the button through the test
buttonhole, lengthen by pulling the button holder on
the foot back to increase length,
® Button holder
] Pull the buttonhole lever down as far as it will go.
(D Buttonhole lever
66