Kenmore 385.19365 - Manual (Page 91)

Darning Stitch
Ф Stitch pattern: 17
® Thread tension dial; AUTO
R: Automatic buttonhole foot
Ф Darning shape: See beiow for setting
e Starting to
Ш Pull the button hoiderto the rear.
Щ Place the garment under the foot. Press the Up/Down
needle position button twice. Remove the fabric to the
left to draw both threads under the foot
m Lower the foot. Press down the foot control.
The machine will lock stitch, sew 16 rows of darning,
iock stitch again and the machine stops automatically.
* The size of one darn cycle is variable.
However, the maximum length is 3/4” (2 cm) and the
maximum width is 9/32” (0,7 cm),
Ш Turn the fabric and repeat sewing
Ф Button holder
® Hole
® Starting point
® 3/4” (2 cm)
® 9/32” (0.7 cm)
e For darning less than 3/4” (2 cm)
stitch to "Lovv" speed setting. 4 Jock stitches will be
sewn first Then sew to the desired length and press
the reverse button. The desired length has now been
determined. Continue sewing until the machine stops
automatically,
® Reverse button
® Desired length
® Starting point
® To adjust the shape of Darning stitch
If one side of the darn Is higher than the other, make
them even by pressing the stitch length V or key.
When you press the or“-"” key, d3 will be indicated
automatically. You can adjust the shape of the darn by
pressing "-t-” or key, d1 to d5.
To memorize Darning stitch
When repeatedly sewing the same-size dam to repair a
side rip or belt loop, press “MEM” key and restart
sewing.
80