beautypg.com

Various utllliy stitches basting, Attaching the embroidery foot, Starting to sew – Kenmore 385.19365 User Manual

Page 63

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Various Utllliy Stitches

Basting

® Stitch pattern:

19

(D Thread tension dial;

1 to 3

(D P: Embroidery foot

® Attaching the Embroidery Foot

[T] Raise the needie

U] Remove the foot holder by loosening the thumb

screw,

iH Attach the Embroidery foot on the presser bar

putting the pin on the needle clamp. Tighten the

thumb screw firmly with a large screwdriver.

(D Pin

0 Needle clamp

^Starting to sew

[T) Lower the feed dogs by switching the drop feed lever to

the right (See page 24)

H] Set the thread tension dial between 1 and 3,

[H Put some fabric under the foot and press Up/down

needle button twice to bring the needie thread down

through the hole in the foot. Pull the fabric and thread

to the rear. Lower the presser foot.

13] While pressing down the foot control, gently pull and

guide the fabric.

m When the machine is stopped after 1 stitch sewing,

pull the threads and fabric to the near side and cut the

threads,

{S Repeat steps IS to Ej to sew. Afrer finishing sewing,

pull the threads and fabric to the rear side.

After sewing, reset the thread tension diai at “AUTO"

and raise the feed dogs, sfide the drop feed lever to

the left.

52