Leica Geosystems Leica mojo3D - User Manual - Manual (Page 357)

Leica mojo3D, mojo3D Enhancements 357
Changing software
configuration,
step-by-step

It is possible to revisit the setup of the mojoXact/mojoXact Plus or attach a
mojoXact/mojoXact Plus after the initial setup of the mojo3D. The steps
below cover both of these scenarios.
To configure software for the mojo3D to mojoXact connection, carry out the
following steps on the mojo3D:
1. On the main navigation screen, tap the Settings button.
2. On the flyout menu, tap the Attached device button.
3. Tap the mojoXact button to continue.