Leica Geosystems Leica mojo3D - User Manual User Manual

Page 210

210

Leica mojo3D, Correction Sources

Turning SBAS on
and off, step-by-
step

To turn SBAS on and off, carry out the following steps:

1. At the main navigation screen, tap the settings button.

2. On the flyout menu tap the correction source button.

3. If the Enable SBAS screen is not

visible, tap the

button until it

appears.
If the Enable SBAS box is grey then
SBAS is turned off. If the box is
green, then SBAS is on.

4. To turn SBAS on or off, tap the Enable SBAS box until it reflects the desired state.

5. Tap the

button to proceed to the main navigation screen.