Leica Geosystems Leica mojo3D - User Manual - Manual (Page 338)

338 Leica mojo3D, mojo3D Enhancements
Initial software
configuration,
step-by-step The mojoXact/mojoXact Plus can be selected as the device to setup when the mojo3D
is first turned on, or it can be setup by the operator accessing the setup wizard at
any time. If the mojoXact/mojoXact Plus is selected when the mojo3D is turned on
for the first time, then follow steps 4 and onwards below.
To setup the mojoXact/mojoXact Plus using the setup wizard, carry out the following
steps:
1. On the main navigation screen, tap the Settings button.
2. On the flyout menu, tap the setup wizard button.
3. On the attached device selection screen, tap the
mojoXact/mojoXact Plus button and tap to continue.
The brightness screen appears.
4. Adjust the slider to vary the brightness of the screen, by tapping and .
5. Tap to continue.
The country selection screen appears.