Leica Geosystems Leica mojo3D - User Manual - Manual (Page 195)

Leica mojo3D, Vehicles and Implements 195
9.6 Importing Vehicle and Implement Configurations
Importing vehicle
and implement
configurations,
step-by-step

Before you can import vehicle or implement configurations, you need to
have a USB memory key that contains vehicle or implement configurations
that were previously exported from a mojo3D.

Refer to "Appendix B Formatting USB Flash Drives" for important informa-
tion about using USB memory keys with the mojo3D products.

Do not turn off the mojo3D, or remove the USB memory key, while the data
import is under way.
To import vehicle and implement configurations, carry out the following steps:
1. The USB interface is on the lower left front of the
mojo3D display. Lift the rubber cover and insert a
compatible USB memory key into the USB slot.
mojo3D_010