Leica Geosystems Leica mojo3D - User Manual - Manual (Page 319)

Leica mojo3D, mojo3D Enhancements 319
12. Configure automatic section control by entering the additional information on
the screen:
• Overlap limit: the percentage amount of overlap that is to be allowed before
the section is turned off.
• Low Speed Shutoff: the minimum travel speed for a section before it is
turned off.
• Off latency: the number of seconds it takes from the section being turned off
until the actual application stops.
• On latency: the number of seconds it takes from the section being turned on
until the actual application starts.

Refer to "7 Automatic Section Control" for a detailed description of
settings.
13. When you have entered all required data on the screen tap to continue.