Leica Geosystems Leica mojo3D - User Manual - Manual (Page 340)

340 Leica mojo3D, mojo3D Enhancements
14. On the mode selection screen, tap the buttons to select:
• top-down mode: either north is at the top of the map screen, or the direction
of the front of the vehicle is at the top of the map screen, and
• display mode: day mode, night mode, or automatic switch between modes.
15. After making your selections, tap to continue.
The lightbar mode screen appears.
The default lightbar mode is the Leica Geosystems Smart lightbar which uses both
cross track error and heading error to guide you to the line. The other choice offered
is the traditional Crosstrack only lightbar.
To configure the lightbar settings, carry out the following steps:
12. On the units selection screen, tap the buttons to select:
• Lengths may be measured in metric, Imperial, or US Standard units.
• Speeds may be measured in metric, Imperial, or US Standard units.
• Areas may be measured in metric, Imperial, or US Standard units. The Imperial
acre is the defined international acre, and the US acre is the slightly smaller US
Survey acre.
13. After making your selections, tap to continue.
The mode selection screen appears.