1 calibrating the section control latency value, Calibrating the section control latency value – Leica Geosystems Leica mojo3D - User Manual User Manual

Page 148

148

Leica mojo3D, Automatic Section Control

7.1.1

Calibrating the Section Control Latency Value



For the purpose of this calibration exercise, if using a boom spray, the tank should
contain only water.

Calibrating latency,
step-by-step

To calibrate the section control latency value, carry out the following steps:

1. Drive slowly in a straight line for

200 m (650 ft) with the master on.
Half way along the run, mark on the
ground where the end of the imple-
ment passes with two pegs and a
rope.