Pilz PSENvip RL D P - Manual (Page 71)

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
5-3
5.2 Install transmitter and receiver
5 Installation
 Both the transmitter and receiver are installed in the same way. Only
the dimensions of the adjustment plates for the transmitter and re-
ceiver are different.
To install the system, proceed as follows:
 Fasten the adjustment plate as shown in the diagram below. Ensure
that the flat washers, spring washers and nuts are attached in the
right order.
Fig. 5-2: Installing the transmitter and receiver
Viewed from the operator's side, the receiver is installed on the left-hand
bracket and the transmitter on the right-hand bracket.
 Slide the nut slot on the adjustment plate into the groove on the
bracket attached to the upper die.
Nut
Auxiliary adjustment plate
Adjustment plate
Flat washer