Pilz PSENvip RL D P - Manual (Page 102)

7.3 Adjustment during tool change
7 Commissioning
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
7-18
The tools are displayed as follows on the PSENvip display:
Fig. 7-17: Tool detection on the PSENvip display
7.3.3 Make adjustment during tool change
Make adjustment during tool change 7- Inbetriebnahme_Justage_bei_Werkzeugwechsel_durchführen_1
To achieve optimum results, the tool should be aligned to an appropriate
bending line during initial commissioning (see section entitled "Initial
commissioning").
There are two ways of starting the function "Adjustment during tool
change":
Option 1
:
 Press the key.
 Using the keys , select the Tool Change option.
 Press the key to start the Tool Change.
SYSTEM OK OSSD OFF
TOOL CHANGE
SYSTEM OK OSSD OFF
TOOL CHANGE
SYSTEM OK OSSD OFF
TOOL CHANGE
Tool class 1 Tool class 2
Tool class 3