Pilz PSENvip RL D P - Manual (Page 59)

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
4-31
4.6 Operating modes during commissioning
4 Function Description
4.6.3 Adjustment during tool change
Adjustment during tool change 4- Funktion_Betriebsarten_Inbetriebnahme_Justage_Werkzeugwechsel_1
The tool is assigned to a tool class in "Tool change" operating mode.
Once the tool data has been saved it is downloaded to the safety sys-
tem.
Funktion_Betriebsarten_Inbetriebnahme_Justage_Werkzeugwechsel
The adjustment line is automatically tracked to the tip of the tool. The
tracking is shown on the display. This makes it easier to adjust to the dif-
ferent tool sizes.
In this operating mode
 The protected field is inactive.
 The OSSDs are switched off.
 There is no protection via the PSENvip.
4.6.4 Setting the parameters for bending angle measurement
Setting the parameters for bending angle measurement 4- Funktion_Betriebsarten_Inbetriebnahme_Biegewinkelmessung
Set and tolerance values for a maximum of 5 angles can be set for bend-
ing angle measurement.
INFORMATION
Generally you should not have to mechanically realign the trans-
mitter and receiver during a tool change.
INFORMATION
Details of the adjustments made during a tool change are
described in Chapter 7, "Commissioning", section entitled
"Adjustment during tool change".
INFORMATION
Details for setting the parameters for bending angle measure-
ment are given in Chapter 7, "Commissioning", under "Setting
the parameters for bending angle measurement".