Pilz PSENvip RL D P - Manual (Page 111)

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
7-27
7.6 Check protective equipment
7 Commissioning
Depending on the level of use, safety devices and safety measures on
the press brake must be checked at least once a year by an appointed
expert (competent person) to ensure they are in a safe condition. The re-
sult of these tests must be entered in the inspection book or in the ma-
chine file. Any serious non-conformances must be rectified before the
press brake is returned to operation.
7.6.1.4 Prepare for function test
Prepare for function test 7- Inbetriebnahme_Schutzeinrichtung_pruefen_Funktionspruefung_vorbereiten
Proceed as follows:
 During initial commissioning the press brake is fully configured with
the upper tool (maximum weight).
 Transmitter and receiver are correctly aligned (see "Initial commis-
sioning").
 The press brake is at top dead centre.
 Transmitter and receiver are ready for operation.
 Standard protected field mode is selected.
INFORMATION
Trained operators must be used for the daily check.
INFORMATION
The annual inspection may only be carried out by qualified per-
sonnel.