Pilz PSENvip RL D P - Manual (Page 44)

4.4 Description of the units
4 Function Description
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
4-16
4.4.3.2 Outputs
Outputs 4- Funktion_Geraete_Empfaenger_Ausgang_OSSD
 OSSD1/OSSD2 in accordance with EN 61496-1, type 4
Two safe outputs that signal the status of the protected field:
OSSD = 1: Protected field clear
OSSD = 0: Protected field broken
Funktion_Geraete_Empfaenger_Ausgang_OSSD_Zusatz_Basis
Funktion_Geraete_Empfaenger_Ausgang_Ausgangstest
Output test
Outputs that are switched on are checked via regular off tests.
 Test pulses for outputs that are switched on: see Technical Details
 Outputs that are switched on are switched off for the duration of the
test pulse.
 The load must not switch off because of the test.
Outputs that are switched off are checked via regular on tests.
 Test pulses for outputs that are switched off: see Technical Details
 Outputs that are switched off are switched on for the duration of the
test pulse.
 The load must not switch on because of the test.
INFORMATION
For details of how to set protected field mode during bending
angle measurement, please see the chapter entitled "Opera-
tion", under "Measure bending angle".
INFORMATION
The programmable safety system uses the signals to shut down
the press stroke at closing speeds >10 mm/s.