Kontron TIGH2U Carrier Grade Server User Manual
Kontron carrier grade server tigh2u
Table of contents
Document Outline
- 1 Introduction
- 2 Features
- 3 Server Component Installations and Upgrades
- 3.1 Before You Begin
- 3.2 General Installation Procedures
- 3.3 Hot-Swappable Component Installation Procedures
- 3.4 Internal System Component Configuration and Installation Procedures
- 3.4.1 Configuring Jumpers on the Server Board
- 3.4.2 Configuring Memory DIMMs
- 3.4.2.1 Memory RASUM Features
- 3.4.2.2 Supported Memory
- 3.4.2.3 DIMM Population Rules and Supported DIMM Configurations
- 3.4.2.4 Non-Mirrored Mode Minimum Configuration
- 3.4.2.5 Non-Mirrored Mode Memory Upgrades
- 3.4.2.6 Mirrored Mode Memory Configuration
- 3.4.2.7 DIMM Sparing Mode Memory Configuration
- 3.4.2.8 Single Branch Mode Sparing
- 3.4.2.9 Dual Branch Mode Sparing
- 3.4.3 Installing DIMMs
- 3.4.4 Removing Memory DIMMs
- 3.4.5 Adding or Replacing a Processor
- 3.4.6 Other Installation and Upgrade Options
- 3.5 Installing the Server into a Rack
- 4 Optional Component Installations
- 5 Server Component Replacements
- 5.1 Before You Begin
- 5.2 Replacing the Fan Assemblies
- 5.3 Replacing the TAM Board
- 5.4 Replacing the SAS Front Panel Board
- 5.5 Replacing the Removable Drive Bay Assembly and the SAS Backplane Board
- 5.6 Replacing the Power Distribution Assembly
- 5.7 Replacing the Server Board
- 5.8 Replacing the CMOS Battery on the Server Board
- 6 Server Utilities
- 7 Troubleshooting
- 7.1 Resetting the System
- 7.2 Problems Following Initial System Installation
- 7.3 Hardware Diagnostic Testing
- 7.4 Specific Problems and Corrective Actions
- 7.4.1 Power Light does not Light
- 7.4.2 No Characters Appear on Screen
- 7.4.3 Characters are Distorted or Incorrect
- 7.4.4 Ctrl-G Option is not available to Configure RAID
- 7.4.5 System Cooling Fans do not Rotate Properly
- 7.4.6 Cannot Connect to a Server
- 7.4.7 Diagnostics Pass but the Connection Fails
- 7.4.8 The Controller Stopped Working When an Add-in Adapter was Installed
- 7.4.9 The Add-in Adapter Stopped Working Without Apparent Cause
- 7.4.10 System Boots When Installing a PCI Card
- 7.4.11 Problems with Newly Installed Application Software
- 7.4.12 Problems with Application Software that Ran Correctly Earlier
- 7.4.13 Devices are not Recognized under Device Manager (Windows* OS)
- 7.4.14 Hard Drive(s) are not Recognized
- 7.5 LED Information
- 7.6 BIOS Error Messages
- 8 Warranty
- Appendix A: Safety Information
- Appendix B: Regulatory and Certification Information
- Appendix C: Getting Help