Kontron TIGH2U Carrier Grade Server - Manual (Page 119)

Kontron Carrier Grade Server TIGH2U
December 2009 Product Guide, rev.1.2
119

Safety Information—TIGH2U Server
Appendix A: Safety Information
Warning: Although you may be using this guide or another resource as a reference, before
working with your server product pay close attention to these safety instructions. You
must adhere to the assembly instructions in this guide to ensure and maintain
compliance with existing product certifications and approvals. Use only the described,
regulated components specified in this guide. Use of other products / components will
void the UL listing and other regulatory approvals of the product and will most likely
result in noncompliance with product regulations in the region(s) in which the product
is sold.
A.1 Emissions Disclaimer
To ensure EMC (Electromagnetic Compatibility) compliance with your local regional rules and
regulations, the final configuration of your end system product may require additional EMC
compliance testing. For more information, please contact your local Kontron representative.
See Appendix B, “Regulatory and Certification Information” for product Safety and EMC regulatory
compliance information. This is an FCC (Federal Communications Commission) Class A device.
A.2 Intended Uses
This product was evaluated as Information Technology Equipment (ITE), which may be installed in
Central Offices, Telecommunication Centers, offices, schools, computer rooms, and similar
commercial type locations where the National Electric Code (NEC) applies. The suitability of this
product for other product categories and environments (medical, industrial, OSP, telecommunications,
residential, alarm systems, test equipment, etc.), other than an ITE application, may require further
evaluation.
Warning: Anchor the equipment rack: The equipment rack must be anchored to an unmovable
support to prevent it from falling over when one or more servers are extended in front
of the rack on slides. You must also consider the weight of any other device installed in
the rack. A crush hazard exists should the rack tilt forward which could cause serious
injury.
A.2.1 If AC Power Supplies are Installed
Mains AC power disconnect: The AC power cord(s) is considered the mains disconnect for the server
and must be readily accessible when installed. If the individual server power cord(s) will not be
readily accessible for disconnection then you must install an AC power disconnect for the entire rack
unit. This main disconnect must be readily accessible, and it must be labeled as controlling power to
the entire rack, not just to the server(s).
Grounding the rack installation: To avoid the potential for an electrical shock hazard, you must include
a third wire safety ground conductor with the rack installation. If the server power cord is plugged
into an AC outlet that is part of the rack, then you must provide proper grounding for the rack itself. If
the server power cord is plugged into a wall AC outlet, the safety ground conductor in the power cord
provides proper grounding only for the server. You must provide additional, proper grounding for the
rack and other devices installed in it.