Kontron TIGH2U Carrier Grade Server - Manual (Page 71)

Kontron Carrier Grade Server TIGH2U
December 2009 Product Guide, rev.1.2
71

Optional Component Installations—TIGH2U Server
4.7.2 Installing a New Optical Device
1. Use the two screws to attach the engagement guide to the optical device.
Figure 53. Attaching the Engagement Guide to the Optical Device
2. Slide the optical drive into the open slot.
With one hand on the front panel and the other behind the backplane board, push against both
sides of the optical drive slot until the engagement guide goes through the backplane board and
the latch pops up to secure the drive in the properly aligned position.
3. Re-attach the retention clip to the engagement guide to ensure the latch keeps the optical drive
properly aligned and locked in place.
Figure 54. Installing the Optical Device into the Chassis
B
A
TS000287