Kontron TIGH2U Carrier Grade Server - Manual (Page 73)

Kontron Carrier Grade Server TIGH2U
December 2009 Product Guide, rev.1.2
73

Server Component Replacements—TIGH2U Server
5 Server Component Replacements
5.1 Before You Begin
Before working with your server product, pay close attention to the safety instructions provided in this
manual. See Appendix A, “Safety Information” .
Warning: Electrostatic discharge (ESD) and ESD protection: ESD can damage disk drives,
boards, and other parts. We recommend that you perform all procedures in this chapter
only at an ESD workstation. If one is not available, provide some ESD protection by
wearing an antistatic wrist strap attached to chassis ground (any unpainted metal
surface) on your server when handling parts.
5.1.1 Tools and Supplies Needed
• #1 and #2 Phillips (cross-point) screwdrivers, or interchangeable tip screwdriver with #1 and #2
Phillips bits
• Socket wrench
• Personal grounding device such as an anti-static wrist strap and a grounded conductive pad
5.1.2 System References
All references to left, right, front, top, and bottom assume that you are facing the front of the server,
as it would be positioned for normal operation.
5.1.3 Cable Routing Reference
It is important for cables to be connected correctly. See Figure 35 on page 53 , and for more detailed
information about cable connectors, see the Kontron Carrier Grade Server TIGH2U Technical Product
Specification.