Kontron TIGH2U Carrier Grade Server - Manual (Page 104)

TIGH2U Server—Server Component Replacements
Kontron Carrier Grade Server TIGH2U
Product Guide, rev.1.2 December 2009
104
6. Install the CPU fan assembly. For instructions, see Section 5.2.3, “Installing the CPU Fan
Assembly” on page 77 .
7. Install the drive bay assembly. For instructions, see Figure 76, “Installing the Drive Bay
Assembly” on page 96 .
8. Connect all cables. Use Figure 35, “System Cable Routing” on page 53 as a reference.
9. Install the bridge board.
10. Install the processor air duct. For instructions, see Section 3.2.6, “Installing the Processor Air
Duct” on page 29 .
11. If this is the last task you are performing, replace the chassis top cover. Reconnect all the external
devices and plug in the power cord(s).
5.8 Replacing the CMOS Battery on the Server Board
The lithium battery on the server board powers the real-time clock (RTC) for up to 10 years in the
absence of power. When the battery starts to weaken, it loses voltage, and the server settings (for
example, the date and time) stored in CMOS RAM in the RTC may be wrong. Contact your Kontron
sales representative or dealer for a list of approved devices.
Caution: Before replacing the battery, you must first take the server out of service, turn off all
peripheral devices connected to the system, turn off the system by pressing the power
button, and unplug the power cord from the system or wall outlet.
WARNING
Danger of explosion if battery is replaced incorrectly. Replace only with the same or equivalent type
recommended by the equipment manufacturer. Discard used batteries according to manufacturer’s
instructions.
WARNING
Lithiumbatteri - Eksplosionsfare ved fejlagtig håndtering. Udskiftning må kun ske med batteri af
samme fabrikat og type. Levér det brugte batteri tilbage til leverandøren.
ADVARSEL
Lithiumbatteri - Eksplosjonsfare. Ved utskifting benyttes kun batteri som anbefalt av
apparatfabrikanten. Brukt batteri returneres apparatleverandøren.
VARNING
Explosionsfara vid felaktigt batteribyte. Använd samma batterityp eller en ekvivalent typ som
rekommenderas av apparattillverkaren. Kassera använt batteri enligt fabrikantens instruktion.
VAROITUS
Paristo voi räjähtää, jos se on virheellisesti asennettu. Vaihda paristo ainoastaan laitevalmistajan
suosittelemaan tyyppiin. Hävitä käytetty paristo valmistajan ohjeiden mukaisesti.
1. Power down the server system and unplug all peripheral devices and the power cable.
2. Remove the chassis cover. For instructions, see
Section 3.2.3, “Removing the Chassis Cover” on
page 26 .
3. Remove the processor air duct. For instructions, see Section 3.2.5, “Removing the Processor Air
Duct” on page 28 .
4. Remove the PCI fan assembly. For instructions, see Section 5.2.4, “Removing the PCI Fan
Assembly” on page 78 .
5. Remove the riser card assembly. For instructions see Section 4.2.2, “Removing the PCI Riser Card
Assembly” on page 56 .
6. Locate the battery. (See Figure 82 .)