Dell POWEREDGE M1000E User Manual
Page 958
B-42
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
OL-13271-03
Appendix B Cisco Catalyst Blade Switch 3130 and 3032 for Dell Debug Commands
debug platform ip igmp snooping
Defaults
Debugging is disabled.
Command Modes
Privileged EXEC
Command History
Usage Guidelines
The undebug platform ip igmp snooping command is the same as the no debug platform ip igmp
snooping command.
On a stacking-capable switch, when you enable debugging, it is enabled only on the stack master. To
enable debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands
rpc [cfg | l3mm | misc
| vlan]
Display IGMP snooping remote procedure call (RPC) event debug messages.
The keywords have these meanings:
•
cfg—(Optional) Display IGMP snooping RPC debug messages.
•
l3mm—(Optional) IGMP snooping Layer 3 multicast router group RPC
debug messages.
•
misc—(Optional) IGMP snooping miscellaneous RPC debug messages.
•
vlan—(Optional) IGMP snooping VLAN assert RPC debug messages.
warn
Display IGMP snooping warning messages.
Release
Modification
12.2(40)EX1
This command was introduced.
Command
Description
Displays information about platform-independent IGMP snooping activity.
show debugging
Displays information about the types of debugging that are enabled.