Dell POWEREDGE M1000E - Manual (Page 279)

2-249
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
OL-13271-03
Chapter 2 Cisco Catalyst Blade Switch 3130 and 3032 for Dell Cisco IOS Commands
ip sticky-arp (interface configuration)
ip sticky-arp (interface configuration)
Use the ip sticky-arp interface configuration command to enable sticky Address Resolution Protocol
(ARP) on a switch virtual interface (SVI) or a Layer 3 interface. Use the no form of this command to
disable sticky ARP.
ip sticky-arp
no ip sticky-arp
Syntax Description This command has no arguments or keywords.
Defaults Sticky ARP is enabled on private-VLAN SVIs.
Sticky ARP is disabled on Layer 3 interfaces and normal SVIs.
Command Modes Interface configuration
Command History
Usage Guidelines Sticky ARP entries are those learned on SVIs and Layer 3 interfaces. These entries do not age out.
The ip sticky-arp interface configuration command is only supported on
• Layer 3 interfaces
• SVIs belonging to normal VLANs
• SVIs belonging to private VLANs
On a Layer 3 interface or on an SVI belonging to a normal VLAN
• Use the sticky-arp interface configuration command to enable sticky ARP.
• Use the no sticky-arp interface configuration command to disable sticky ARP.
On private-VLAN SVIs
• When you configure a private VLAN, sticky ARP is enabled on the switch (the default).
If you enter the ip sticky-arp interface configuration command, it does not take effect.
If you enter the no ip sticky-arp interface configuration command, you do not disable sticky ARP
on an interface.
Note We recommend that you use the show arp privileged EXEC command to display and verify
private-VLAN interface ARP entries.
Release Modification
12.2(40)EX1 This command was introduced.