Dell POWEREDGE M1000E - Manual (Page 955)

B-39
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
OL-13271-03
Appendix B Cisco Catalyst Blade Switch 3130 and 3032 for Dell Debug Commands
debug platform ip arp inspection
debug platform ip arp inspection
Use the debug platform ip arp inspection privileged EXEC command to debug dynamic Address
Resolution Protocol (ARP) inspection events. Use the no form of this command to disable debugging.
debug platform ip arp inspection {all | error | event | packet | rpc}
no debug platform ip arp inspection {all | error | event | packet | rpc}
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug platform ip arp inspection command is the same as the no debug platform ip arp
inspection command.
On a stacking-capable switch, when you enable debugging, it is enabled only on the stack master. To
enable debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands
all Display all dynamic ARP inspection debug messages.
error Display dynamic ARP inspection error debug messages.
event Display dynamic ARP inspection event debug messages.
packet Display dynamic ARP inspection packet-related debug messages.
rpc Display dynamic ARP inspection remote procedure call (RPC) request debug
messages.
Release Modification
12.2(40)EX1 This command was introduced.
Command Description
show inventory Displays the dynamic ARP inspection configuration and operating state.
show debugging Displays information about the types of debugging that are enabled.