Dell POWEREDGE M1000E - Manual (Page 934)

B-18
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
OL-13271-03
Appendix B Cisco Catalyst Blade Switch 3130 and 3032 for Dell Debug Commands
debug lldp packets
debug lldp packets
Use the debug lldp packets privileged EXEC command to enable debugging of Link Layer Discovery
Protocol (LLDP) packets. Use the no form of this command to disable debugging.
debug lldp packets
no debug lldp packets
Syntax Description This command has no arguments or keywords.
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug lldp packets command is the same as the no debug lldp packets command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands
Release Modification
12.2(50)SE This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.