Network-policy profile (global configuration) – Dell POWEREDGE M1000E User Manual
Page 403
2-373
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
OL-13271-03
Chapter 2 Cisco Catalyst Blade Switch 3130 and 3032 for Dell Cisco IOS Commands
network-policy profile (global configuration)
network-policy profile (global configuration)
Use the network-policy profile global configuration command to create a network-policy profile and to
enter network-policy configuration mode. Use the no form of this command to delete the policy and to
return to global configuration mode.
network-policy profile profile number
no network-policy profile profile number
Syntax Description
Defaults
No network-policy profiles are defined.
Command Modes
Global configuration
Command History
Usage Guidelines
Use the network-policy profile global configuration command to create a profile and to enter
network-policy profile configuration mode.
To return to the privileged EXEC mode from the network-policy profile configuration mode, enter the
exit command.
When you are in network-policy profile configuration mode, you can create the profile for voice and
voice-signalling by specifying the values for VLAN, class of service (CoS), differentiated services code
point (DSCP), and tagging mode.
These profile attributes are then contained in the Link Layer Discovery Protocol for Media Endpoint
Devices (LLDP-MED) network-policy time-length-value (TLV).
Examples
This example shows how to create network-policy profile 60:
Switch(config)# network-policy profile 60
Switch(config-network-policy)#
Related Commands
profile number
Specify the network-policy profile number. The range is 1 to
4294967295.
Release
Modification
12.2(50)SE
This command was introduced.
Command
Description
Applies a network-policy to an interface.
network-policy profile
(network-policy configuration)
Configures the attributes of network-policy profiles.
Displays the configured network-policy profiles.