Dell POWEREDGE M1000E User Manual
Page 745
2-715
Cisco Catalyst Blade Switch 3120 for HP Command Reference
OL-12248-03
Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands
spanning-tree guard
ports. When the switch is operating in MST mode, BPDUs are not sent on nonboundary interfaces if the
interface is blocked by loop guard in all MST instances. On a boundary interface, loop guard blocks the
interface in all MST instances.
To disable root guard or loop guard, use the spanning-tree guard none interface configuration
command. You cannot enable both root guard and loop guard at the same time.
You can override the setting of the spanning-tree loopguard default global configuration command by
using the spanning-tree guard loop interface configuration command.
Examples
This example shows how to enable root guard on all the VLANs associated with the specified port:
Switch(config)# interface gigabitethernet2/0/2
Switch(config-if)# spanning-tree guard root
This example shows how to enable loop guard on all the VLANs associated with the specified port:
Switch(config)# interface gigabitethernet2/0/2
Switch(config-if)# spanning-tree guard loop
You can verify your settings by entering the show running-config privileged EXEC command.
Related Commands
Command
Description
show running-config
Displays the operating configuration. For syntax information,
use this link to the Cisco IOS Release 12.2 Command
Reference listing page:
Select the Cisco IOS Commands Master List, Release 12.2
to navigate to the command.
Sets the path cost for spanning-tree calculations.
spanning-tree loopguard default
Prevents alternate or root ports from becoming designated
ports because of a failure that leads to a unidirectional link.
Configures the path cost for MST calculations.
spanning-tree mst port-priority
Configures an interface priority.
Configures the MST root switch priority and timers based on
the network diameter.
Configures an interface priority.
priority
Sets the switch priority for the specified spanning-tree
instance.