Show dot1q-tunnel – Dell POWEREDGE M1000E User Manual
Page 513
2-483
Cisco Catalyst Blade Switch 3120 for HP Command Reference
OL-12248-03
Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands
show dot1q-tunnel
show dot1q-tunnel
Use the show dot1q-tunnel user EXEC command to display information about IEEE 802.1Q tunnel
ports.
show dot1q-tunnel [interface interface-id] [ | {begin | exclude | include} expression]
Syntax Description
Command Modes
User EXEC
Command History
Usage Guidelines
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
Examples
These are examples of output from the show dot1q-tunnel command:
Switch> show dot1q-tunnel
dot1q-tunnel mode LAN Port(s)
-----------------------------
Gi1/0/1
Gi1/0/2
Gi1/0/3
Gi1/0/6
Po2
Switch> show dot1q-tunnel interface gigabitethernet1/0/1
dot1q-tunnel mode LAN Port(s)
-----------------------------
Gi1/0/1
Related Commands
interface interface-id
(Optional) Specify the interface for which to display IEEE 802.1Q tunneling
information. Valid interfaces include physical ports and port channels.
| begin
(Optional) Display begins with the line that matches the expression.
| exclude
(Optional) Display excludes lines that match the expression.
| include
(Optional) Display includes lines that match the specified expression.
expression
Expression in the output to use as a reference point.
Release
Modification
12.2(40)EX1
This command was introduced.
Command
Description
dot1q tag native
Displays IEEE 802.1Q native VLAN tagging status.
dot1q-tunnel
Configures an interface as an IEEE 802.1Q tunnel port.