Dell POWEREDGE M1000E - Manual (Page 923)

B-7
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
OL-13271-03
Appendix B Cisco Catalyst Blade Switch 3130 and 3032 for Dell Debug Commands
debug dtp
debug dtp
Use the debug dtp privileged EXEC command to enable debugging of the Dynamic Trunking Protocol
(DTP) activity. Use the no form of this command to disable debugging.
debug dtp {aggregation | all | decision | events | oserrs | packets | queue | states | timers}
no debug dtp {aggregation | all | decision | events | oserrs | packets | queue | states | timers}
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug dtp command is the same as the no debug dtp command.
On a stacking-capable switch, when you enable debugging, it is enabled only on the stack master. To
enable debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands
aggregation Display DTP user-message aggregation debug messages.
all Display all DTP debug messages.
decision Display the DTP decision-table debug messages.
events Display the DTP event debug messages.
oserrs Display DTP operating system-related error debug messages.
packets Display DTP packet-processing debug messages.
queue Display DTP packet-queueing debug messages.
states Display DTP state-transition debug messages.
timers Display DTP timer-event debug messages.
Release Modification
12.2(40)EX1 This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.
show dtp Displays DTP information for the switch or for a specified interface.