Dell POWEREDGE M1000E - Manual (Page 940)

B-24
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
OL-13271-03
Appendix B Cisco Catalyst Blade Switch 3130 and 3032 for Dell Debug Commands
debug nmsp
debug nmsp
Use the debug nmsp privileged EXEC command to the enable debugging of the Network Mobility
Services Protocol (NMSP) on the switch. This command is available only when your switch is running
the cryptographic (encrypted) software image. Use the no form of this command to disable debugging.
debug nmsp {all | connection | error | event | packet | rx | tx}
no debug nmsp
Syntax Description This command has no arguments or keywords.
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug nmsp command is the same as the no debug nmsp command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands
Release Modification
12.2(50)SE This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.
show nmsp Displays the NMSP information.