Dell POWEREDGE M1000E User Manual
Page 396
2-366
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
OL-13271-03
Chapter 2 Cisco Catalyst Blade Switch 3130 and 3032 for Dell Cisco IOS Commands
monitor session
Examples
This example shows how to create a local SPAN session 1 to monitor both sent and received traffic on
source port 1 on stack member 1 to destination port 2 on stack member 2:
Switch(config)# monitor session 1 source interface gigabitethernet1/0/1 both
Switch(config)# monitor session 1 destination interface gigabitethernet1/0/2
This example shows how to delete a destination port from an existing local SPAN session:
Switch(config)# no monitor session 2 destination gigabitethernet1/0/2
This example shows how to limit SPAN traffic in an existing session only to specific VLANs:
Switch(config)# monitor session 1 filter vlan 100 - 110
This example shows how to configure RSPAN source session 1 to monitor multiple source interfaces and
to configure the destination RSPAN VLAN 900.
Switch(config)# monitor session 1 source interface gigabitethernet1/0/1
Switch(config)# monitor session 1 source interface port-channel 2 tx
Switch(config)# monitor session 1 destination remote vlan 900
Switch(config)# end
This example shows how to configure an RSPAN destination session 10 in the switch receiving the
monitored traffic.
Switch(config)# monitor session 10 source remote vlan 900
Switch(config)# monitor session 10 destination interface gigabitethernet1/0/2
This example shows how to configure the destination port for ingress traffic on VLAN 5 by using a
security device that supports IEEE 802.1Q encapsulation. Egress traffic replicates the source; ingress
traffic uses IEEE 802.1Q encapsulation.
Switch(config)# monitor session 2 destination interface gigabitethernet1/0/2 encapsulation
dot1q ingress dot1q vlan 5
This example shows how to configure the destination port for ingress traffic on VLAN 5 by using a
security device that does not support encapsulation. Egress traffic and ingress traffic is untagged.
Switch(config)# monitor session 2 destination interface gigabitethernet1/0/2 ingress
untagged vlan 5
You can verify your settings by entering the show monitor privileged EXEC command. You can display
SPAN and RSPAN configurations on the switch by entering the show running-config privileged EXEC
command. SPAN information appears near the end of the output.
Related Commands
Command
Description
Configures an RSPAN VLAN in vlan configuration mode.
Displays SPAN and RSPAN session information.
show running-config
Displays the operating configuration. For syntax information, use
this link to the Cisco IOS Release 12.2 Command Reference listing
page:
Select the Cisco IOS Commands Master List, Release 12.2 to
navigate to the command.