Debug pagp – Dell POWEREDGE M1000E User Manual
Page 942
B-26
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
OL-13271-03
Appendix B Cisco Catalyst Blade Switch 3130 and 3032 for Dell Debug Commands
debug pagp
debug pagp
Use the debug pagp privileged EXEC command to enable debugging of Port Aggregation Protocol
(PAgP) activity. Use the no form of this command to disable debugging.
debug pagp [all | dual-active | vent | fsm | misc | packet]
no debug pagp [all | dual-active | event | fsm | misc | packet]
Syntax Description
Defaults
Debugging is disabled.
Command Modes
Privileged EXEC
Command History
Usage Guidelines
The undebug pagp command is the same as the no debug pagp command.
On a stacking-capable switch, when you enable debugging, it is enabled only on the stack master. To
enable debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands
all
(Optional) Display all PAgP debug messages.
dual-active
(Optional) Dispaly dual-active detection messages.
event
(Optional) Display PAgP event debug messages.
fsm
(Optional) Display PAgP finite state-machine debug messages.
misc
(Optional) Display miscellaneous PAgP debug messages.
packet
(Optional) Display PAgP packet debug messages.
Release
Modification
12.2(40)EX1
This command was introduced.
12.2(46)SE
The dual-active keyword was added.
Command
Description
show debugging
Displays information about the types of debugging that are enabled.
Displays PAgP channel-group information.