Dell POWEREDGE M1000E - Manual (Page 235)

2-205
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
OL-13271-03
Chapter 2 Cisco Catalyst Blade Switch 3130 and 3032 for Dell Cisco IOS Commands
ip dhcp snooping binding
ip dhcp snooping binding
Use the ip dhcp snooping binding privileged EXEC command on the switch stack or on a standalone
switch to configure the DHCP snooping binding database and to add binding entries to the database. Use
the no form of this command to delete entries from the binding database.
ip dhcp snooping binding mac-address vlan vlan-id ip-address interface interface-id expiry
seconds
no ip dhcp snooping binding mac-address vlan vlan-id ip-address interface interface-id
This command is supported only if your switch is running the IP services feature set.
Syntax Description
Defaults No default database is defined.
Command Modes Privileged EXEC
Command History
Usage Guidelines Use this command when you are testing or debugging the switch.
In the DHCP snooping binding database, each database entry, also referred to a binding, has an IP
address, an associated MAC address, the lease time (in hexadecimal format), the interface to which the
binding applies, and the VLAN to which the interface belongs. The database can have up to 8192
bindings.
Use the show ip dhcp snooping binding privileged EXEC command to display only the configured
bindings. Use the show ip source binding privileged EXEC command to display the dynamically and
statically configured bindings.
Examples This example shows how to generate a DHCP binding configuration with an expiration time of
1000 seconds on a port in VLAN 1:
Switch# ip dhcp snooping binding 0001.1234.1234 vlan 1 172.20.50.5 interface
gigabitethernet1/0/1 expiry 1000
You can verify your settings by entering the show ip dhcp snooping binding or the show ip dhcp source
binding privileged EXEC command.
mac-address Specify a MAC address.
vlan vlan-id Specify a VLAN number. The range is 1 to 4094.
ip-address Specify an IP address.
interface interface-id Specify an interface on which to add or delete a binding entry.
expiry seconds Specify the interval (in seconds) after which the binding entry is no longer
valid. The range is 1 to 4294967295.
12.2(40)EX1 This command was introduced.