Dell POWEREDGE M1000E - Manual (Page 180)

2-150
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
OL-13271-03
Chapter 2 Cisco Catalyst Blade Switch 3130 and 3032 for Dell Cisco IOS Commands
duplex
duplex
Use the duplex interface configuration command on the switch stack or on a standalone switch to specify
the duplex mode of operation for a port. Use the no form of this command to return the port to its default
value.
duplex {auto | full | half}
no duplex
Syntax Description
Defaults The default is auto for Gigabit Ethernet ports.
You cannot configure the duplex mode on 10-Gigabit Ethernet ports or on internal 1000 Mb/s ports; it is
always full.
The default is full for the 100BASE- LX small form-factor pluggable (SFP) modules.
Duplex options are not supported on the 1000BASE-SX SFP modules.
For information about which SFP modules are supported on your switch, see the product release notes.
Command Modes Interface configuration
Command History
Usage Guidelines For Gigabit Ethernet ports, setting the port to auto has the same effect as specifying full if the attached
device does not autonegotiate the duplex parameter.
Note Half-duplex mode is supported on Gigabit Ethernet interfaces if the duplex mode is auto and the
connected device is operating at half duplex. However, you cannot configure these interfaces to
operate in half-duplex mode.
Certain ports can be configured to be either full duplex or half duplex. Applicability of this command
depends on the device to which the switch is attached.
If both ends of the line support autonegotiation, we highly recommend using the default autonegotiation
settings. If one interface supports autonegotiation and the other end does not, configure duplex and speed
on both interfaces; do use the auto setting on the supported side.
auto Enable automatic duplex configuration; port automatically detects whether it
should run in full- or half-duplex mode, depending on the attached device mode.
full Enable full-duplex mode.
half Enable half-duplex mode (only for interfaces operating at 10 or 100 Mb/s). You
cannot configure half-duplex mode for interfaces operating at 1000 or
10,000 Mb/s.
Release Modification
12.2(40)EX1 This command was introduced.