Show system mtu – Dell POWEREDGE M1000E User Manual
Page 699
2-669
Cisco Catalyst Blade Switch 3120 for HP Command Reference
OL-12248-03
Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands
show system mtu
show system mtu
Use the show system mtu privileged EXEC command to display the global maximum transmission unit
(MTU) or maximum packet size set for the switch.
show system mtu [ | {begin | exclude | include} expression]
Syntax Description
Command Modes
Privileged EXEC
Command History
Usage Guidelines
If you have used the system mtu or system mtu jumbo global configuration command to change the
MTU setting, the new setting does not take effect until you reset the switch.
For information about the MTU values and the stack configurations that affect the MTU values, see the
command.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
Examples
This is an example of output from the show system mtu command:
Switch# show system mtu
System MTU size is 1500 bytes
System Jumbo MTU size is 1500 bytes
On next reload, System Jumbo MTU will be 9198 bytes
Routing MTU size is 1500 bytes
Related Commands
| begin
(Optional) Display begins with the line that matches the expression.
| exclude
(Optional) Display excludes lines that match the expression.
| include
(Optional) Display includes lines that match the specified expression.
expression
Expression in the output to use as a reference point.
Release
Modification
12.2(40)EX1
This command was introduced.
Command
Description
Sets the MTU size for the Gigabit Ethernet, 10-Gigabit Ethernet, or routed
ports.