Dell POWEREDGE M1000E - Manual (Page 1003)

B-87
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
OL-13271-03
Appendix B Cisco Catalyst Blade Switch 3130 and 3032 for Dell Debug Commands
debug sw-vlan ifs
debug sw-vlan ifs
Use the debug sw-vlan ifs privileged EXEC command to enable debugging of the VLAN manager IOS
file system (IFS) error tests. Use the no form of this command to disable debugging.
debug sw-vlan ifs {open {read | write} | read {1 | 2 | 3 | 4} | write}
no debug sw-vlan ifs {open {read | write} | read {1 | 2 | 3 | 4} | write}
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug sw-vlan ifs command is the same as the no debug sw-vlan ifs command.
On a stacking-capable switch, when you enable debugging, it is enabled only on the stack master. To
enable debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
When selecting the file read operation, Operation 1 reads the file header, which contains the header
verification word and the file version number. Operation 2 reads the main body of the file, which
contains most of the domain and VLAN information. Operation 3 reads type length version (TLV)
descriptor structures. Operation 4 reads TLV data.
Related Commands
open {read | write} Display VLAN manager IFS file-open operation debug messages. The
keywords have these meanings:
• read—Display VLAN manager IFS file-read operation debug messages.
• write—Display VLAN manager IFS file-write operation debug messages.
read {1 | 2 | 3 | 4} Display file-read operation debug messages for the specified error test (1, 2, 3,
or 4).
write Display file-write operation debug messages.
Release Modification
12.2(40)EX1 This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.
show vlan Displays the parameters for all configured VLANs or one VLAN (if the
VLAN name or ID is specified) in the administrative domain.