Debug interface – Dell POWEREDGE M1000E User Manual
Page 929
B-13
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
OL-13271-03
Appendix B Cisco Catalyst Blade Switch 3130 and 3032 for Dell Debug Commands
debug interface
debug interface
Use the debug interface privileged EXEC command to enable debugging of interface-related activities.
Use the no form of this command to disable debugging.
debug interface {interface-id | null interface-number | port-channel port-channel-number |
vlan vlan-id}
no debug interface {interface-id | null interface-number | port-channel port-channel-number |
vlan vlan-id}
Syntax Description
Defaults
Debugging is disabled.
Command Modes
Privileged EXEC
Command History
Usage Guidelines
If you do not specify a keyword, all debug messages appear.
The undebug interface command is the same as the no debug interface command.
On a stacking-capable switch, when you enable debugging, it is enabled only on the stack master. To
enable debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands
interface-id
Display debug messages for the specified physical port, identified by type
switch number/module number/ port, for example gigabitethernet 1/0/2.
null interface-number
Display debug messages for null interfaces. The interface-number is always
0.
port-channel
port-channel-number
Display debug messages for the specified EtherChannel port-channel
interface. The port-channel-number range is 1 to 64.
vlan vlan-id
Display debug messages for the specified VLAN. The vlan-id range is 1 to
4094.
Release
Modification
12.2(40)EX1
This command was introduced.
Command
Description
show debugging
Displays information about the types of debugging that are enabled.
Displays EtherChannel information for the channel.