Dell POWEREDGE M1000E User Manual
Page 142
2-112
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
OL-13271-03
Chapter 2 Cisco Catalyst Blade Switch 3130 and 3032 for Dell Cisco IOS Commands
diagnostic monitor
Defaults
Monitoring is disabled, and a failure threshold value is not set.
Command Modes
Global configuration
Command History
Usage Guidelines
Follow these guidelines when configuring health-monitoring diagnostic testing:
•
name—Enter the
content privileged EXEC command to display the test names in
the test ID list.
•
test-id—Enter the
content command to display the test numbers in the test ID list.
•
test-id-range—Enter the
content command to display the test numbers in the test
ID list. Enter the range as integers separated by a comma and a hyphen (for example, 1,3-6 specifies
test IDs 1, 3, 4, 5, and 6).
•
hh—Enter the hours from 0 to 24.
•
mm—Enter the minutes from 0 to 60.
•
ss—Enter the seconds from 0 to 60.
•
milliseconds—Enter the test time in milliseconds from 0 to 999.
•
day—Enter the number of days between test from 0 to 20.
•
Enter the diagnostic monitor test 1 command to enable diagnostic monitoring.
You must configure the failure threshold and the interval between tests before enabling diagnostic
monitoring.
When entering the diagnostic monitor switch number test {name | test-id | test-id-range | all}
command, you must isolate network traffic by disabling all connected ports, and do not send test packets
during the test.
Examples
This example shows how to configure a health-monitoring test:
Switch(config)# diagnostic monitor threshold switch 2 test 1 failure count 20
Switch(config)# diagnostic monitor interval switch 2 test 1 12:30:00 750 5
Related Commands
threshold
Configure the failure threshold.
failure count
count
Set the failure threshold count. The range for count is from 0 to 99.
Release
Modification
12.2(40)EX1
This command was introduced.
Command
Description
Displays online diagnostic test results.