Dell POWEREDGE M1000E - Manual (Page 336)

2-306
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
OL-13271-03
Chapter 2 Cisco Catalyst Blade Switch 3130 and 3032 for Dell Cisco IOS Commands
mac address-table static
mac address-table static
Use the mac address-table static global configuration command on the switch stack or on a standalone
switch to add static addresses to the MAC address table. Use the no form of this command to remove
static entries from the table.
mac address-table static mac-addr vlan vlan-id interface interface-id
no mac address-table static mac-addr vlan vlan-id [interface interface-id]
Syntax Description
Defaults No static addresses are configured.
Command Modes Global configuration
Command History
Examples This example shows how to add the static address c2f3.220a.12f4 to the MAC address table. When a
packet is received in VLAN 4 with this MAC address as its destination, the packet is forwarded to the
specified interface:
Switch(config)# mac address-table static c2f3.220a.12f4 vlan 4 interface
gigabitethernet6/0/1
You can verify your setting by entering the show mac address-table privileged EXEC command.
Related Commands
mac-addr Destination MAC address (unicast or multicast) to add to the address
table. Packets with this destination address received in the specified
VLAN are forwarded to the specified interface.
vlan vlan-id Specify the VLAN for which the packet with the specified MAC address
is received. The range is 1 to 4094.
interface interface-id Interface to which the received packet is forwarded. Valid interfaces
include physical ports and port channels.
Release Modification
12.2(40)EX1 This command was introduced.
Command Description
show mac address-table static Displays static MAC address table entries only.