Dell POWEREDGE M1000E - Manual (Page 380)

2-350
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
OL-13271-03
Chapter 2 Cisco Catalyst Blade Switch 3130 and 3032 for Dell Cisco IOS Commands
mls qos srr-queue input dscp-map
mls qos srr-queue input dscp-map
Use the mls qos srr-queue input dscp-map global configuration command on the switch stack or on a
standalone switch to map Differentiated Services Code Point (DSCP) values to an ingress queue or to
map DSCP values to a queue and to a threshold ID. Use the no form of this command to return to the
default setting.
mls qos srr-queue input dscp-map queue queue-id {dscp1...dscp8 | threshold threshold-id
dscp1...dscp8}
no mls qos srr-queue input dscp-map
Syntax Description
Defaults Table 2-11 shows the default DSCP input queue threshold map:
Command Modes Global configuration
Command History
Usage Guidelines The DSCP assigned at the ingress port selects an ingress or egress queue and threshold.
The drop-threshold percentage for threshold 3 is predefined. It is set to the queue-full state. You can
assign two weighted tail-drop (WTD) threshold percentages to an ingress queue by using the mls qos
srr-queue input threshold global configuration command.
queue queue-id Specify a queue number.
For queue-id, the range is 1 to 2.
dscp1...dscp8 Map DSCP values to an ingress queue.
For dscp1...dscp8, enter up to eight values, and separate each value with a
space. The range is 0 to 63.
threshold threshold-id
dscp1...dscp8 Map DSCP values to a queue threshold ID.
For threshold-id, the range is 1 to 3.
For dscp1...dscp8, enter up to eight values, and separate each value with a
space. The range is 0 to 63.
Table 2-11 Default DSCP Input Queue Threshold Map
DSCP Value Queue ID–Threshold ID
0–39 1–1
40–47 2–1
48–63 1–1
Release Modification
12.2(40)EX1 This command was introduced.