Dell POWEREDGE M1000E - Manual (Page 378)

2-348
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
OL-13271-03
Chapter 2 Cisco Catalyst Blade Switch 3130 and 3032 for Dell Cisco IOS Commands
mls qos srr-queue input cos-map
mls qos srr-queue input cos-map
Use the mls qos srr-queue input cos-map global configuration command on the switch stack or on a
standalone switch to map class of service (CoS) values to an ingress queue or to map CoS values to a
queue and to a threshold ID. Use the no form of this command to return to the default setting.
mls qos srr-queue input cos-map queue queue-id {cos1...cos8 | threshold threshold-id
cos1...cos8}
no mls qos srr-queue input cos-map
Syntax Description
Defaults Table 2-10 shows the default CoS input queue threshold map:
Command Modes Global configuration
Command History
Usage Guidelines The CoS assigned at the ingress port selects an ingress or egress queue and threshold.
The drop-threshold percentage for threshold 3 is predefined. It is set to the queue-full state. You can
assign two weighted tail-drop (WTD) threshold percentages to an ingress queue by using the mls qos
srr-queue input threshold global configuration command.
queue queue-id Specify a queue number.
For queue-id, the range is 1 to 2.
cos1...cos8 Map CoS values to an ingress queue.
For cos1...cos8, enter up to eight values, and separate each value with a
space. The range is 0 to 7.
threshold threshold-id
cos1...cos8 Map CoS values to a queue threshold ID.
For threshold-id, the range is 1 to 3.
For cos1...cos8, enter up to eight values, and separate each value with a
space. The range is 0 to 7.
Table 2-10 Default CoS Input Queue Threshold Map
CoS Value Queue ID - Threshold ID
0–4 1–1
5 2–1
6, 7 1–1
Release Modification
12.2(40)EX1 This command was introduced.