Dell POWEREDGE M1000E - Manual (Page 953)

B-37
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
OL-13271-03
Appendix B Cisco Catalyst Blade Switch 3130 and 3032 for Dell Debug Commands
debug platform etherchannel
debug platform etherchannel
Use the debug platform etherchannel privileged EXEC command to enable debugging of
platform-dependent EtherChannel events. Use the no form of this command to disable debugging.
debug platform etherchannel {init | link-up | rpc | warnings}
no debug platform etherchannel {init | link-up | rpc | warnings}
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug platform etherchannel command is the same as the no debug platform etherchannel
command.
On a stacking-capable switch, when you enable debugging, it is enabled only on the stack master. To
enable debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands
init Display EtherChannel module initialization debug messages.
link-up Display EtherChannel link-up and link-down related debug messages.
rpc Display EtherChannel remote procedure call (RPC) debug messages.
warnings Display EtherChannel warning debug messages.
Release Modification
12.2(40)EX1 This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.