Dell PowerEdge M605 - Manual (Page 85)

Command Groups 47
Tunnel Interface Commands
distribute-list out Specifies the access list to filter routes received from the
source protocol. RIP
enable Resets the default administrative mode of RIP in the router
(active). RIP
hostroutesaccept Enables the RIP hostroutesaccept mode. RIP
ip rip Enables RIP on a router interface. IC
ip rip authentication Sets the RIP Version 2 Authentication Type and Key for the
specified interface. IC
ip rip receive version Configures the interface to allow RIP control packets of the
specified version(s) to be received. IC
ip rip send version Configures the interface to allow RIP control packets of the
specified version to be sent. IC
redistribute Configures OSPF protocol to allow redistribution of routes
from the specified source protocol/routers. ROSPF
router rip Enters Router RIP mode. GC
show ip rip Displays information relevant to the RIP router. PE
show ip rip interface Displays information related to a particular RIP interface. PE
show ip rip interface brief Displays general information for each RIP interface. PE
split-horizon Sets the RIP split horizon mode. RIP
*NOTE: For the meaning of each Mode abbreviation, see Mode Types on page 4.
Command Description Mode*
interface tunnel Enables the interface configuration mode for a tunnel. GC
show interface tunnel Displays the parameters related to tunnel such as tunnel
mode, tunnel source address and tunnel destination
address. PE
tunnel destination Specifies the destination transport address of the tunnel. IC
tunnel mode ipv6ip Specifies the mode of the tunnel. IC
tunnel source Specifies the source transport address of the tunnel, either
explicitly or by reference to an interface. IC
*NOTE: For the meaning of each Mode abbreviation, see Mode Types on page 4.
Command Description Mode*