Dell PowerEdge M605 - Manual (Page 74)

36 Command Groups
www
.dell.com | support.dell.com
IP Routing Commands
IPv6 Routing Commands
Command Description Mode*
encapsulation Configures the link layer encapsulation type for the packet. IC
ip address Configures an IP address on an interface. IC
ip mtu Sets the IP Maximum Transmission Unit (MTU) on a
routing interface. IC
ip netdirbcast E nables the forwarding of network-directed broadcasts. IC
ip route Configures a static route. Use the no form of the command
to delete the static route. GC
ip route default Configures the default route. Use the no form of the
command to delete the default route. GC
ip route distance Sets the default distance (preference) for static routes. GC
ip routing Globally enables IPv4 routing on the router. GC
routing Enables IPv4 and IPv6 routing for an interface. IC
show ip brief Displays all the summary information of the IP. PE
show ip interface Displays all pertinent information about the IP interface. PE
show ip protocols Displays the parameters and current state of the active
routing protocols. PE
show ip route Displays the routing table. PE
show ip route preferences Displays detailed information about the route preferences. PE
show ip route summary Shows the number of all routes, including best and non-
best routes. PE
show ip stats Displays IP statistical information UE
*NOTE: For the meaning of each Mode abbreviation, see Mode Types on page 4.
Command Description Mode*
clear ipv6 neighbors Clears all entries in the IPv6 neighbor table or an entry on a
specific interface. PE
clear ipv6 statistics Clears IPv6 statistics for all interfaces or for a specific
interface, including loopback and tunnel interfaces. PE
ipv6 address Configures an IPv6 address on an interface (including
tunnel and loopback interfaces). IC