Dell PowerEdge M605 - Manual (Page 638)

642 IPv6 Routing Commands
www
.dell.com | support.dell.com
console(config)#no ipv6 unicast-routing
ping ipv6
Use ping ipv6 command in Privileged EXEC mode to determine whether another computer is on
the network. To use the command, configure the switch for network (in-band) connection. The
source and target devices must have the ping utility enabled and running on top of TCP/IP. The
switch can be pinged from any IP workstation with which the switch is connected through the
default VLAN (VLAN 1), as long as there is a physical path between the switch and the
workstation. The terminal interface sends three pings to the target station.
Syntax
ping ipv6 ipv6-address [size size]
• ipv6-address—Target IPv6 address to ping.
• size—Size of the datagram. (Range: 48-2048 bytes)
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Example
The following example determines whether another computer is on the network at the IPv6
address specified.
console(config)#ping ipv6 2030:1::1/64
Send count=3, Receive count=0 from 2030:1::1/64
Average round trip time = 0.00 ms
ping ipv6 interface
Use ping ipv6 interface command in the Privileged EXEC mode to determine whether another
computer is on the network. To use the command, configure the switch for network (in-band)
connection. The source and target devices must have the ping utility enabled and running on top
of TCP/IP. The switch can be pinged from any IP workstation with which the switch is connected
through the default VLAN (VLAN 1), as long as there is a physical path between the switch and the