Dell PowerEdge M605 - Manual (Page 501)

Syslog Commands 495
logging facility
Use the logging facility command in Global Configuration mode to set the facility for logging
messages. To reset to the default value, use the no form of the command.
Syntax
logging facility facility
no logging facility
• facility—The facility that will be indicated in the message. (Range: local0, local1, local2,
local3, local4, local5, local 6, local7)
Default Configuration
The default value is local7.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example sets the logging facility as local3.
console(config)#logging facility local3
logging file
Use the logging file command in Global Configuration mode to limit syslog messages sent to the
logging file based on severity. To cancel the buffer, use the no form of this command.
Syntax
logging file level
no logging file
• level—Limits the logging of messages to the buffer to a specified level. (Range:
emergency, alert, critical, error, warning, notice, info, debug)
Default Configuration
The default value for level is error.
Command Mode
Global Configuration mode