Dell PowerEdge M605 - Manual (Page 687)

OSPF Commands 693
• key-id—Authentication key identifier for the authentication type encrypt. (Range: 0-255)
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
Unauthenticated interfaces do not need an authentication key or authentication key ID.
Example
The following example sets the OSPF Authentication Type and Key for VLAN 15.
console(config-if-vlan15)#ip ospf authentication encrypt test123
100
ip ospf cost
Use the ip ospf cost command in Interface Configuration mode to configure the cost on an OSPF
interface. Use the no form of the command to return the cost to the default value.
Syntax
ip ospf cost integer
no ip ospf cost
• integer—Specifies the cost (link-state metric) of the OSPF interface. (Range: 1-65535)e
Default Configuration
10 is the default link-state metric configuration.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
This command has no user guidelines.
Example
The following example configures the cost on the OSPF interface at 5.
console(config-if-vlan15)#ip ospf cost 5