Dell PowerEdge M605 - Manual (Page 304)

282 System Management Commands
www
.dell.com | support.dell.com
The following example uses the iterative process to obtain command parameters, and displays
the routes that packets actually take when traveling to their destination.
console#traceroute
traceroute# Enter the ip-address|hostname : 192.168.77.171
traceroute# Packet size (default: 40 bytes): 30
traceroute# Max ttl value (default: 20): 10
traceroute# Number of probes to send at each level (default 3):
traceroute# Timeout (default: 3 seconds): 6
traceroute# Source ip-address (default to select best interface
address):
traceroute# Type of Service byte (default):
Tracing route over a maximum of 20 hops
1 192.168.21.1 30 ms 10 ms 10 ms
2 * * *
3 * * *
4 * * *
5 * * *